3M™ CP2 Press-Fit Header, CP2 Series
- | Select product options for IDs.
Details
Highlights
- 25 mm basic system unit
- 2 mm grid spacing allows for high signal density at low cost
- “Eye of the Needle” compliant pin press-fit design helps reduce manufacturing time and cost
- Three contact mating levels for Early Mate Late Break or “Hot Swap” applications reduces manufacturing time and cost
- Feed through termination available for midplane applications
- Additional grounding rows available for improved ground bounce and EMI immunity
- Mates with 5 row 3M™ MetPak™ HSHM, UHM and CP2 sockets
- End to end stackable with 5 row 3M™ MetPak™ HSHM, HM and CP2 headers
- See Regulatory Information Appendix (last page of Tech Data Sheet) for chemical compliance information
- For more information, refer to Data Sheet TS2270 (TS-2270)
The 3M™ CP2 Press-Fit Header, CP2 Series helps achieve high signal density in cost-effective applications. Modular headers use a basic unit of 25 mm with 2 mm grid spacing. Type C 55, 2 mm signal contacts with left guidance feature a press-fit pin design that helps verify smooth and accurate connections. Three contact mating levels make these headers excellent for hot swapping and early mate/late break applications.
End-stackable header mates with 5 row 3M™ MetPak™ sockets. The 3M press-fit header, CP2 series is available with additional grounding rows for improved ground bounce and EMI control, as well as feed through termination for midplane applications.
Specifications
Resources
Support
Ask a 3M Expert
Our apologies.
An error has occurred while submitting. Please try again later.
Thank you!
Your form was submitted successfully.
